Installing The System; General Requirements - Vertiv NetSure 7100 Installation Manual

Vertiv™ NetSure™ 7100 -48 VDC Power System Installation Manual

Fuses Installed (if required)
Setting Jumper and Switch Options

Jumper on System Interface Circuit Card Set

Factory Switch Setting on IB2 (Controller Interface Board) Verified

Factory Switch Setting on Optional EIB (Controller Extended Interface Board) Verified
Making Electrical Connections

System Frame Ground Connection Made

Central Office Ground Connection Made

AC Input and AC Input Equipment Grounding Connections Made

External Alarm, Reference, Monitoring, and Control Connections Made

NCU Controller Ethernet Port Connection Made (if required)

NCU Controller Second Ethernet Port Connection Made (if required)

Load Connections Made

Battery Connections Made
Installing Rectifier Modules

Rectifier Modules Installed
Initially Starting the System

System Started, Configured, and Checked

3 Installing the System

3.1 General Requirements

•
This product is intended only for installation in a restricted access location on or above a non-combustible surface.
•
This product must be located in a controlled environment with access to crafts persons only.
•
This product is intended for installation in network telecommunication facilities (CO, vault, hut, or other environmentally
controlled electronic equipment enclosure).
•
This product is intended for connection to the common bonding network in a network telecommunication facility (CO, vault,
hut, or other environmentally controlled electronic equipment enclosure).
•
The DC return connection to this system can remain isolated from system frame and chassis (DC-I).
•
The installer should be familiar with the installation requirements and techniques to be used in securing the system to an
equipment rack.
•
The system must be mounted in an environment that does not exceed the rated operating ambient temperature range found
in SAG582127000.
2