External Alarm, Reference, Monitoring, And Control Connections; Location Of Circuit Cards With External Alarm, Reference, Monitoring, And Control Connectors - Vertiv NetSure 7100 Installation Manual

Vertiv™ NetSure™ 7100 -48 VDC Power System Installation Manual

5.4 External Alarm, Reference, Monitoring, and Control Connections

The various circuit cards inside the distribution cabinet contain external alarm, reference, monitoring, and control connectors.
5.4.1 Location of Circuit Cards with External Alarm, Reference, Monitoring, and Control
Connectors
Refer to Figure 5.2.
Figure 5.2: Location of Circuit Cards with External Alarm, Reference, Monitoring, and Control Connectors
IB2 (Interface Board)
(installed at bottom of shelf)
18
Front
USB-B Port
(Factory connected
to NCU Controller
backplane.)
CAN Bus
Termination
Resistor
System Interface Board
(installed on side panel)
Front
Panel
Removed
Optional
EIB (Extended Interface Board)
(installed at bottom of shelf)
USB-A Port
(not used)
IB4 Second Ethernet Port Board
(installed at bottom of shelf)
10M Ethernet Port (RJ-45)
LAN Connection