Setting Jumper And Switch Options; Location Of Circuit Cards With Jumper And Switch Options - Vertiv NetSure 7100 Installation Manual

Vertiv™ NetSure™ 7100 -48 VDC Power System Installation Manual

4 Setting Jumper and Switch Options

The various circuit cards inside the distribution cabinet contain jumper and/or switch options.

4.1 Location of Circuit Cards with Jumper and Switch Options

Refer to Figure 4.1.
Figure 4.1: Location of Circuit Cards with Jumper and Switch Options
10
Front
IB2 (Interface Board)
(installed at bottom of shelf)
CAN Bus
Termination
Resistor
System Interface Board
(installed on side panel)
Front
Panel
Removed
Optional
EIB (Extended Interface Board)
(installed at bottom of shelf)