Kubota L4400 Workshop Manual page 97

L4400 , WSM
Tractor Manuals Scotland
Draining the Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1), (2).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1), (2).
(When refilling)
• Fill up new oil from the oil filling port (3) up to the upper line of the
oil level gauge (4).
• After running the engine for few minutes, stop it and check the oil
level again, add oil to prescribed level, if necessary.
Transmission fluid
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluides
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands of oil together.
(1) Drain Plug
(2) Drain Plug
(3) Oil Filling Port
(4) Oil Level Gauge
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. Loosen the drain plug (1) to drain the coolant.
3. Remove the radiator cap (2) to completely drain the coolant.
4. After all coolant is drained, retighten the drain plug (1).
(When refilling)
• Fill the coolant between the "FULL" and "LOW" marks of
recovery tank.
Coolant capacity (with recovery tank)
(1) Drain Plug
(2) Radiator Cap
(3) Recover Tank
Tractor Manuals Scotland - Please Do Not Copy
1-S22
40 L
Capacity 10.6 U.S.qts
8.8 Imp.qts
A : Oil level is acceptable within this
range.
6.0 L
6.9 U.S.qts
5.7 Imp.qts
(A) FULL
(B) LOW
ENGINE
W1040435
W1062137
KiSC issued 07, 2007 A