Disassembling And Assembling; Clutch Housing - Kubota L4400 Workshop Manual

L4400 , WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Clutch Housing

Tractor Manuals Scotland
Clutch Lever, Release Fork and Release Bearing
1. Remove the release fork mounting screws (2).
2. Draw out the clutch lever (3) to remove the release fork (1).
3. Remove the release bearing (4) together with release holder.
(When reassembling)
• Apply grease to the sliding surface of the clutch release hub.
• Apply grease to the clutch lever.
Tightening torque
(1) Release Fork
(2) Release Fork Mounting Screw
Shaft Case
1. Remove the shaft case mounting screws.
2. Remove the shaft case (1) by using two jack screws M6.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
surface of the shaft case and clutch housing case after
eliminating the water, oil and stuck liquid gasket.
(When replacing oil seal in shaft case)
• Install the oil sea (3) as shown in the figure, noting its direction.
• Apply grease to the oil seal (3).
Tightening torque
(1) Shaft Case
(2) Jack Screw M6
Tractor Manuals Scotland - Please Do Not Copy
3-S20
23.5 to 27.5 N·m
Release fork mounting
2.4 to 2.8 kgf·m
screw
17.4 to 20.3 ft-lbs
(3) Clutch Lever
(4) Release Bearing
23.5 to 27.5 N·m
Release fork setting screw 2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(3) Oil Seal
TRANSMISSION
W1014296
W1017592
KiSC issued 07, 2007 A