Disassembling And Assembling - Kubota L4400 Workshop Manual

L4400 , WSM

[3] DISASSEMBLING AND ASSEMBLING

Tractor Manuals Scotland
Brake Case
1. Remove the brake case mounting screws and nuts.
2. Separate the brake case, tapping the brake case lever lightly.
(When reassembling)
• Apply grease to the brake ball seats.
excessively.)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the brake case and transmission case, around hole
A after eliminate the water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate to the transmission case.
Tightening torque
Brake Case, Brake Assembly
1. Remove the brake case mounting screw(1).
2. Remove the brake case (2).
3. Remove the brake shaft (3) with brake discs (6) and plates(7).
4. Remove the brake cam plate (5) and steel balls.
(When reassembling)
• Place the brake discs (6) so that the hole (A) of brake discs
should be overlapped 50% or more.
• Apply liquid gasket (Three Bond 1208D or equivalent to joint face
of the brake case and differential gear case, after eliminate the
water, oil and stuck liquid fasket.
Tightening torque
(1) Brake Case Mounting Screw
(2) Brake Case
(3) Brake Shaft
(4) Steel Ball
Tractor Manuals Scotland - Please Do Not Copy
5-S8
38.2 to 45.1 N·m
Brake case mounting stud
3.9 to 4.6 kgf·m
bolt
28.2 to 33.3 ft-lbs
77.5 to 90.2 N·m
Brake case mounting
7.9 to 9.2 kgf·m
screw and nut
57.1 to 66.5 ft-lbs
62.8 to 72.5 N·m
Brake case lever monting
6.4 to 7.4 kgf·m
screw
46.3 to 53.5 ft-lbs
197 to 226 N·m
Rear wheel mounting
20 to 23 kgf·m
screw and nut
145 to 166 ft-lbs
(5) Brake Cam Plate
(6) Brake Disc
(7) Plate
BRAKES
(Do not grease
W1015066
W1017134
KiSC issued 07, 2007 A