To Use A Usb Connection - Honeywell CGW-MB Installation And User Manual

Gent Panels
3. Power Connection
NOTE: The external power supply must be dedicated and not shared with any other
devices.
NOTE: The panel's power supply to the CLSS Gateway mainboard must be within +24V DC
power.
On the CLSS Gateway mainboard Side
1. Connect to the 24V DC external power supply.
2. Ensure that the S7 switch next to the RS-232 port is switched towards NUP_OUT.
On the Panel Side
Connect the power cable into the 24V DC external power supply.

To Use a USB Connection

1. On the CLSS Gateway mainboard Side
Connect the USB-C side of the cable to the USB port of the CLSS Gateway mainboard.
The USB port is labeled as 8 in the figure
2. On the Panel Side
In the MCC card on the panel:
Connect the USB-B side of the cable. Refer to the figure
3. Power Connection
Connect the CLSS Gateway mainboard to a 24V DC external power source.
NOTE: The external power supply must be dedicated and not shared with any other
devices.
NOTE: The panel's power supply to the CLSS Gateway mainboard must be within +24V DC
power.
CGW-MB Installation and Users' Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
Figure C.23: The S7 Switch
Figure C.2.
Connecting to the Panels
Figure C.22.
169