User Information - Honeywell CGW-MB Installation And User Manual

User Information

• This equipment complies with radio frequency exposure limits set forth by Industry
Cananda for an uncontrolled environment.
• This equipment should be installed and operated with a minimum distance of 20 cm
between the device and the user or bystanders.
Déclarations de mise en garde:
• Cet équipement est conforme aux limites d'exposition aux radiofréquences défines par
Indstrie Canada pourun environment non contrôlé.
• Cet équipement doit être installé et utilisé aven un minimum de 20 cm de distance
dispositif et l'utilisateur ou des tiers.
Tant que 2 conditions ci-dessus sont remplies, un autre test d'émetteur ne sera pas
nécessaire. Toutefois, l'intégrateur OEM est toujours responsable de tester leur produit final
pour toutes les exigences de conformité supplémentaires requises avec ce module installé.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain
laptop configurations or co-location with another transmitter), then the Canada
authorization is no longer considered valid and IC ID cannot be used on the final product. In
these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate Canada authorization.
Étiquetage final des produits :
Ce module émetteur n'est autorisé que pour une utilisation dans les appareils où l'antenne
peut être installée de telle sorte que 20cm peut être maintenu entre l'antenne et les
utilisateurs. Le produit final doit être étiqueté dans la zone visible avec ce qui suit:
"Contient IC: 1609A CGWMBSOM ".
NFPA Compliance (USA)
Install the CGW-MB in accordance with the National Fire Protection Association Installation
Standard NFPA 72.
CSFM
CSFM ID: 7300-1637:0504
FDNY
COA# 2020-TMCOAP-000121-AMND
COA# 2020-TMCOAP-000122-AMND
1.7 User Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CGW-MB Installation and Users' Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
General Information
13