C.4: Esser Panels; C.4.1: Connection Options - Honeywell CGW-MB Installation And User Manual

ESSER Panels
C.4 ESSER Panels
If Inventory Synchronization and events are required, use both the RS-232 and RS-485
connection. Refer to the
To Use an RS-485 Connection
If only events are required, use either the RS-232 or RS-485 connection. Refer to the
Use an RS-485 Connection
C.4.1 Connection Options
The CLSS Gateway mainboard operates only with the ESSER fire alarm control panels as
listed in the table below:
Minimum Required Versions
ESCOM panel: 02.06.011
FlexES panel: 4.07R001
IQ8 panel: 03.13R000
CGW-MB: 3.1.4.78
CGW-MB Installation and Users' Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
To Use an RS-232 Connection for Inventory Synchronization
section.
or To Use an RS232 Connection for Events
Table C.2: ESSER Panel Connection Options
Fire Alarm Panel Models
ESCOM
FlexES Control
IQ8Control C
IQ8Control M
1 Use a TTY-RS-232 converter (764856)
2 Use the RS-485 module (784871) along with SEI-2 Card (Serial Essernet®
Interface) (784850)
3 Use the RS-232 module (772386) along with SEI Card (Serial Essernet®
Interface) (784856)
RS-485 UART/TTL
No No
Yes No
2
Yes No
2
Yes No
Connecting to the Panels
section.
RS-232 USB
Yes No
1
Yes No
1 or 3
Yes No
1 or 3
Yes No
and
To
140