Table of Contents
Advertisement
Battery Connection
3.5 Battery Connection
The RPS-1000 battery charge capacity is 7 to 33 AH. Use 12V batteries of the same AH rating. Determine the correct AH rating as per the
current load calculation (see Table 2.4 and Table 2.5 or Table 2.6).
NOTE: If the backup battery requirements indicate the use of batteries that are too large to fit into the RPS-1000 cabinet, use the RBB Remote
Battery Box cabinet. Refer to the RBB Installation Instructions #151306.
Wire batteries in series to produce a 24-volt equivalent. Do not parallel batteries to increase the AH rating.
3.6 Connecting the RPS-1000 to the FACP
1.
Connect the RPS-1000 to the appropriate SBUS. The RPS-1000 can be connected directly to the FACP or it can be daisy-chained to
another RPS-1000. Refer to Figures 3.5 and 3.6.
2.
Use the onboard DIP switch to assign an ID number. (See Section 3.6.1) Figure 2.1 shows the location of the DIP switches on the RPS-
1000 board.
3.
Add the RPS-1000 module to the system and configure the module using JumpStart auto-programming or by manually entering
information into the FACP.
It is possible to assign a name to the module. These procedures are described in the FACP Installation Manuals. Refer to Table 1.1.
.
FACP SBUS
RPS-1000 Terminals 30-33 are used only for
connection RPS-1000 to the FACP or to the controlling
RPS-1000.
Use RPS-1000 Terminals 16-19 to connect other SBUS
modules (SLC expanders, annunciators, 5824) and to
daisy-chain RPS-1000 modules.
RPS-1000 Manual — P/N 151153:R 2/15/2022
to panel
_
+
_
+
Figure 3.4 Battery Connection
RPS-1000 Board
(RPS-1000-1)
Connect other SBUS modules here.
Figure 3.5 Class B RPS-1000 Connection to FACP
Replace batteries every five years.
Battery Jumper
(P/N 140694)
Maximum wire length is 6,000 feet.
See Section 2.6 for more information.
RPS-1000 Board
(RPS-1000-2)
Installation
To next RPS-1000
and other SBUS
modules
29
Advertisement
Table of Contents
