Table of Contents
Advertisement
4.
Read the note and press OK to continue the Gearbox Matching function.
Figure 5-26 Sample of gearbox matching function (screen 1)
5.
Wait until the message 'Successful operation' pops up.
5.9.
GEAR LEARNING
The crankshaft position sensor learns crankshaft tooth machining tolerance
and saves to the tablet to more accurately diagnose engine misfires. If gear
learning is not performed for a car equipped with a Delphi engine, the MIL
turns on after the engine is started. The diagnostic device detects the DTC
P1336 'Gear not learned'. In this case, you must use the diagnostic device to
perform gear learning for the car. After gear learning is successful, the MIL
turns off. This function can complete the self-learning of the gearbox and
improve the quality of shifting.
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is
replaced, or the DTC 'gear not learned' is present, gear learning must be
performed.
60
Advertisement
Table of Contents
