Xtool H6 Pro User Manual page 57

indicators displaying. A service regeneration can be requested in the
workshop using the diagnostic tool.
DPF regeneration is used to clear PM (Particulate Matter) from the DPF filter
through continuous combustion oxidation mode (such as high-temperature
heating combustion, fuel additive, or catalyst to reduce PM ignition
combustion) to stabilize the filter performance.
DPF regeneration may be performed in the following cases:
The exhaust back pressure sensor is replaced.
⚫
The PM trap is removed or replaced.
⚫
The fuel additive nozzle is removed or replaced.
⚫
The catalytic oxidizer is removed or replaced.
⚫
The DPF regeneration MIL is on and maintenance is performed.
⚫
The DPF regeneration control module is replaced.
⚫
The operation guidelines of the DPF function are shown below:
1. Enter the DPF menu and choose relevant models according to the
vehicle being tested.
2. Enter the DPF regeneration menu.
3. Read carefully and complete the requisites listed before performing the
DPF regeneration function. And press OK after completing the
instructions shown.
48