Figure 32 Attach The Bcm50 To The Rackmount Shelf - Nortel BCM50 Installation And Maintenance Manual

To install the BCM50 unit on the rackmount shelf
1 Place the BCM50 unit on the rack so that the unit's feet are in the depressions in the shelf.
2 Move the unit forward until the unit's feet touch the front side of the depressions.
3
Slide the unit back until the unit's feet click in place on the tabs in the depressions (see
32).

Figure 32 Attach the BCM50 to the rackmount shelf

4 If you want to further secure the unit, use four of the self-tapping screws for plastic supplied
with the rackmount kit to attach the unit to the rackmount shelf. Make sure the screw holes in
the unit are aligned with the holes in the rackmount shelf. Then drive the four screws through
the holes in the bottom of the shelf and into the screw holes in the bottom of the unit.
Caution: Use only the screws supplied with the rackmount kit (NT9T6325). Do not
replace the screws. Other screws can damage the unit.
5
Contiue with the next step,
To install a BCM50 unit on top of another unit
1 Insert the power supply retention clip into the BCM50 unit.
2 Place the BCM50 unit on top of the other unit. Make sure the unit's feet are in the slots on the
top of the unit and in front of the tabs (see
Install the BCM50 unit in an equipment rack
"Install the power supply on the rackmount shelf" on page
Figure 33 on page 100).
Install the BCM50 units
99
Figure
100.