98
Install the BCM50 unit in an equipment rack
Install the rackmount shelf in an equipment rack
To install the rackmount shelf
1
Determine the location in the rack where you want to install the BCM50 unit.
2
Position the rackmount shelf in the rack.
3
Align the holes in the rackmount shelf with the holes in the equipment rack rails.
4
Fasten the rackmount shelf to the rack using the four rack screws (supplied with the rackmount
kit). See
Figure
Figure 31 Fasten the rackmount shelf to an equipment rack
5
Continue with the next step,
Install the BCM50 unit on the rackmount shelf
The rackmount shelf has tabs molded into its surface that allow you to attach the BCM50 units to
the shelf. By attaching the BCM50 units to these tabs you can prevent them from accidently being
knocked off the rackmount shelf.
If you are installing additional units, you can install a second unit on the shelf beside the first unit.
You can install another unit on top of each of the first two units. Nortel Networks recommends a
maximum of four units per rackmount shelf.
Select your installation option:
•
"To install the BCM50 unit on the rackmount shelf" on page 99
•
"To install a BCM50 unit on top of another unit" on page 99
Install the BCM50 units
31.
"Install the BCM50 unit on the rackmount
shelf".