94
Unpack the BCM50 Main Unit
Refer to the following sections for information on installing the BCM50 Main Unit:
•
"Unpack the BCM50 Main Unit" on page 94
•
"Mount the BCM50 Main Unit" on page 94
•
"Next step" on page 95
Unpack the BCM50 Main Unit
Open the BCM50 Main Unit box and check that you have all of the components listed below:
•
one main unit (either a BCM50, a BCM50a, or a BCM50e)
•
one BCM50 power supply
•
one power supply cable
•
one power supply retention clip
•
four rubber feet
•
a documentation CD
•
the BCM50 First Time Installation Guide
Visually inspect the components for any damage that may have occurred during shipping.
If you find any damage, contact your Nortel Networks sales representative.
Mount the BCM50 Main Unit
Before you mount the BCM50 Main Unit, you need to decide how you want to mount the unit.
Nortel Networks provides the following methods for mounting the BCM50 Main Unit:
•
Rackmount
•
Wallmount
•
Desktop mount
Rackmount
To rackmount a BCM50 unit, you need a rackmount shelf. The rackmount shelf mounts in a
standard 19-inch equipment rack. The BCM50 unit mounts into the tabs on the rackmount shelf.
These tabs prevent the unit from sliding around or falling off the shelf. If the BCM50 system
includes additional units, another unit can be mounted to a second set of tabs on the rackmount
shelf. Any additional units can be mounted to tabs on the top of the other units. An optional patch
panel simplifies the cable connections for the lines and extensions.
Install the BCM50 Main Unit