Install The Bcm50 Unit On The Wallmount Bracket; Figure 35 Wallmount Lock In Unlock Position - Nortel BCM50 Installation And Maintenance Manual

11 Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the cable
trough.
12 If the BCM50 system has only one unit, skip
bracket" on page
If the BCM50 system has more than one unit, continue with the following steps.
13 Prepare the additional wallmount bracket using the descriptions in step 5.
14 Place the additional wallmount bracket on the backboard on the right side of the existing
wallmount bracket. Use the alignment tabs to ensure the two wallmount brackets are properly
aligned.
15 Use three #8 x 2 cm (#8 x 0.75 in.) round-head wood screws to secure the wallmount bracket
to the backboard (see
16 Open the cable management door.
17 Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the cable
trough.
18 Repeat steps 13 to 17 for each additional unit.
If this is the last wallmount bracket for the BCM50 system, continue to
unit on the wallmount bracket" on page

Install the BCM50 unit on the wallmount bracket

To install the BCM50 unit on the wallmount bracket
1 Insert the power supply retention clip into the BCM50 unit.
2 Slide the wallmount lock fully to the right (unlock position). See

Figure 35 Wallmount lock in unlock position

103.
Figure 34 on page
Install the BCM50 unit on the wall
to"Install the BCM50 unit on the wallmount
102).
103.
"Install the BCM50
Figure 35.
Install the BCM50 units
103