Remove A Table Mounted Bcm50 Expansion Unit; Remove The Media Bay Module; Figure 68 Remove A Media Bay Module - Nortel BCM50 Installation And Maintenance Manual

198

Remove the media bay module

Remove a table mounted BCM50 Expansion Unit

To remove a table mounted BCM50 Expansion Unit:
1
Ensure that all of the cables are removed from the BCM50 Expansion Unit.
If they are not, refer to
2
If there is a unit mounted to the top of the BCM50 Expansion Unit, slide that unit forward until
it disengages from the clips on the BCM50 Expansion Unit. Lift the unit off the top of the
BCM50 Expansion Unit and set it on a flat, clean, static-free surface.
3 If the BCM50 Expansion Unit is mounted on top of another unit, slide the BCM50 Expansion
Unit forward until it disengages from the clips of the other unit.
4 Lift the BCM50 Expansion Unit off of the table or other unit and set it on a flat, clean,
static-free surface.
5 Continue to the next step,

Remove the media bay module

After you have removed the BCM50 Expansion Unit, use the following procedure to remove the
media bay module (MBM) from the BCM50 Expansion Unit:
1 Attach one end of a grounding strap to your wrist and the other end to a grounded metal
surface.
2 Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers.
Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the
BCM50 Expansion Unit. Refer to diagram below.

Figure 68 Remove a media bay module

3
Grasp the top and bottom edges of the MBM. Remove the MBM from the BCM50 Expansion
Unit. Place the MBM in a flat, clean, and static-free surface.
Replace a BCM50 Expansion Unit
"Disconnect the BCM50 Expansion Unit cables" on page
"Remove the media bay module" on page
196.
198.
Grasp the edge of the MBM
ejector lever and pull outward