Remove The Hard Disk; Figure 72 Hard Disk Cables - Nortel BCM50 Installation And Maintenance Manual

Remove the hard disk

To remove the BCM50 hard disk:
Caution: Do not use an electric or magnetized screwdriver near the hard disk. You
can lose the information stored on the disk. Shock can damage the hard disk. Do not
drop or hit the hard disk drive.
1 Attach one end of a grounding strap to your wrist and the other end to a grounded metal
surface.
2 Ensure the BCM50 case is open. If it is not, refer to
3
Remove the Serial ATA cable from the hard disk. Refer to the figure
page 207 for the location of the cable.
4
Remove the power cable from the hard disk. Refer to

Figure 72 Hard disk cables

5
Lift the hard disk and hard disk bracket out of the BCM50 and place is on a flat, clean,
static-free surface.
6 Remove the four screws that secure the hard disk to the hard disk bracket.
Remove an internal component
"Open the BCM50 case" on page
Figure 72 for the location of the cable.
Power Serial ATA
cable cable
Replace an internal component
207
204.
"Hard disk cables" on