Switching On The Server - Fujitsu PRIMERGY TX1310 M5 Upgrade And Maintenance Manual

Figure 25: Connecting the power cords
▶ If applicable, connect the power cord for the monitor to the lower socket (1).
▶ Connect the power cord of the PSU to the upper socket (2).
▶ Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
It will take about 60 seconds until the server can be powered on.
4.9

Switching on the server

CAUTION
▶
Before switching on the server, make sure the side cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
▶
For more information, see
▶ Connect all peripheral cables to the server.
TX1310 M5
"Important information" on page
Upgrade and Maintenance Manual
Basic hardware procedures
25.
57