Fujitsu PRIMERGY TX1310 M5 Upgrade And Maintenance Manual page 93

RAID level Procedure
RAID 0 Only remove an HDD module combined in a RAID 0 array if
defective.
RAID 1 Removing an HDD module from a RAID 1 array will not result in
data loss. However, the removed drive needs to be replaced
RAID 5
immediately by an HDD module of the same or larger capacity.
RAID 6
RAID 10
In order to permanently remove an operational HDD module that is part of a
RAID array from the server, you first need to delete the array using HII
Configuration Utility.
CAUTION
All data on all HDDs in the array will be lost when deleting the RAID
array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see RAID documentation in
documents" on page
TX1310 M5
CAUTION
RAID 0 provides no data redundancy.
In case of an HDD module is defect, all data are lost!
After replacing the HDD module, RAID rebuild will be
performed as a background process, see
a RAID array rebuild" on page
23.
Upgrade and Maintenance Manual
Hard disk drives (HDD)
"Performing
69.
"List of
93