Removing An M.2 Ssd - Fujitsu PRIMERGY TX1310 M5 Upgrade And Maintenance Manual

▶ Disconnect all storage devices from the server beside the M.2 SSD.
▶ Power on the server. Once the server has been started, then enter the BIOS
setup menu and select the DVD drive as primary boot device.
▶ Insert the CD into the DVD drive and reboot the server. The server will boot
from the installer CD.
▶ Follow the on-screen instructions to install the ESXi. When the installation is
complete, you will be asked to reboot the server.
▶ While the server is rebooting, enter the BIOS setup menu again and select
the M.2 SSD as primary boot device.
The installation of the ESXi to the M.2 SSD is complete.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
The M.2 SSD can be used only for boot device. Do not use VMFS on
the M.2 SSD because of not meeting required endurance. For more
information, see the VMware Knowledge Base 2145210.
https://kb.vmware.com/s/article/2145210
For Japan
In order to setup the ESXi, see the corresponding version of the
"VMware vSphere Software Description" from the following URL and
reinstall ESXi to the M.2 SSD.
https://jp.fujitsu.com/platform/server/primergy/software/vmware/manual/
15.5.3

Removing an M.2 SSD

Upgrade and Repair Unit
(URU)
Tools: tool-less
TX1310 M5 Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
201