Fujitsu PRIMERGY TX1310 M5 Upgrade And Maintenance Manual page 211

▶ If applicable, remove the TPM, see
Installing the new system board
▶ Check the settings on the new system board, see
page 235.
▶ Insert the system board by holding it at a slight angle.
▶ Slide the connectors into the connector panel.
Figure 142: System board screws
▶ Lower the system board onto the centering bolts (see orange circles).
▶ Ensure that the system board is properly seated on both centering bolts.
▶ Fasten the centering bolts of the system board with two screws (see orange
circles).
TX1310 M5
"Removing the TPM" on page
Upgrade and Maintenance Manual
System board and components
"Onboard settings" on
191.
211