Figure 146: Removing the connectors from top HDD cage
▶ Pinch the sides of the connector (1) and remove it from the top HDD cage
(2).
▶ Disconnect all system cable connectors from the system board.
▶ Remove the defective cable.
Installing the new system cable
▶ Install the new cable to the top HDD cage and accessible drives.
▶ Connect the cables to the system board.
For more cabling information, see
page
239.
▶
"Installing the standard PSU" on page
▶
"Installing the ODD" on page
▶ Push back the RDX backup drive until it snaps into place.
▶ If applicable, install HDD3 and HDD4, see
page
90.
TX1310 M5
77.
161.
Upgrade and Maintenance Manual
"Supplied documents" on
"Installing a 3.5-inch HDD" on
Cables
219