Christie CP2420-Xe Installation And Setup Manual page 28

2. Remove the knockout plate located in the bottom-right corner of the front bezel.
The AC supply is routed to the terminal block through a strain relief mounted on this knockout
plate.
3. Connect the AC power cables to the terminal block, beginning with the ground lead first.
Use an appropriately sized strain relief connector with the knockout plate provided to ensure
adequate environmental sealing and to prevent the cables from wear and accidentally being
torn out.
CP2420-Xe and CP4420-Xe Installation and Setup Guide
020-103555-01 Rev. 1 (03-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
28