Figure 23. Flow Rate Adjustment Cell Cap; Figure 24. Flow Rate Adjustment Automatic Cell Cleaning Device/ Mcu - Deckma Hamburg OMD-2008 Series Instruction Manual

Flow rate adjustments can be made by Cell Cap, MCU or the Automatic Cell Cleaning
Device.
Adjust the flow rate through the unit by using the O-Rings in the normal Cell Cap.
Low Flow:
Medium Flow:
High Flow:

Figure 23. Flow Rate Adjustment Cell Cap

For instruments equipped with a MCU or an Automatic Cell Cleaning Device a high or a
low flow rate can be adjusted.
Low Flow:
High Flow:

Figure 24. Flow Rate Adjustment Automatic Cell Cleaning Device/ MCU

For more information about the Flow Control and Cleaning Frequency, see 22.2.2
Functional Button "ON".
Let all three O-Rings inside the cap.
Take out the inside O-Ring 4.5x2.
Let the Main O-Ring 11.5x3 as figured below.
Let the smaller O-Ring 9.5x2 inside the MCU/ Auto Clean
Remove the smaller O-Ring 9.5x2.
Page: 47 of 102