Specification Omd-2008 Eva - Deckma Hamburg OMD-2008 Series Instruction Manual

6.1

Specification OMD-2008 EVA

Range:
Accuracy:
Linearity:
Display:
Power Supply:
Consumption:
Alarm Points 1 + 2:
Alarm 1 Operating Delay:
(for annunciation purpose)
Alarm 2 Operating Delay:
(for control purposes)
Alarm Indication:
(Alarm 1, 2 System Fault)
Alarm Contact Rating:
(Alarm 1, 2, System Fault)
Output Signal:
Sample/ Fresh Water Pressure:
Sample Flow:
Sample Water Temperature:
Ambient Temperature:
Roll:
Size:
(Computer Unit)
(Automatic Cell Cleaning Device)
(Measuring Cell)
Weight:
Degree of Protection:
Air Supply
Air Pressure Regulator
Pipe Connections: Air, Water
 Technical specifications are subject to change without notification.
*By request the alarm set point can be set to 5 ppm max.
0 – 30 ppm, Trend indication 50 ppm
According IMO MEPC. 107(49)
0 – 30 ppm better than ± 2 %
Yellow Graphic Display
24 V – 240 V AC or DC
Automatic Voltage selection
< 10 VA
Adjustable between 1 – 15 ppm*
(Works adjustment 15 ppm)
Adjustable between 1 – 540 sec.
(Works adjustment 2 sec.)
Adjustable between 1 – 10 sec.
(Works adjustment 10 sec.)
Red LEDs
Potential free 1 pole change over contacts,
3 A / 240 V
0 – 20 mA or 4 – 20 mA selectable, active,
ext. Load < 150 
0 – 6 bar recommended range of installation
Approx. 2 l/min
+ 1 to + 65° C
+ 1 to + 55° C
Up to 45°
200 mm W x 240 mm H x 100 mm D
140 mm W x 240 mm H x 120 mm D
140 mm W x 280 mm H x 120 mm D
7 kg
IP 65
4 – 6 bar
Typical 4 bar
R ¼" Female
Page: 29 of 102