7.4
Piping OMD-2008 EVFC
Connect the OMD-2008 EVFC Monitor to the sample point of the oily-water separator
outlet and to a source of oil free water. Fittings on the instrument are for 10mm OD
stainless steel (clean water) and 6 mm OD stainless steel or copper pipes (sample water/
outlet). Adapter fittings for other pipe diameters are available upon request.
The sampling point should be located on a vertical section of the separator outflow piping
to minimize the effects of any entrained air. The sampling point should be at a level above
the outlet of the monitor to ensure the sample cell is flooded at all times.
Figure 16. Piping OMD-2008 EVFC
Page: 38 of 102