Deckma Hamburg OMD-2008 Series Instruction Manual page 4

IMPORTANT NOTICE
Replacement components for 15 ppm Bilge Alarms
General
All monitors in our range are inspected and tested to the related International Maritime
Organization IMO requirements at our factories prior to delivery.
In normal use the units should operate correctly and without fault over a long period of time
requiring only small amounts of maintenance to be carried out as outlined in the instruction
manual.
Service Exchange Units
In the event of a monitor malfunction due to electrical or electronic component failure it is our
recommendation that a service exchange unit be ordered.
The defective instrument should be returned to our works within 30 days of supplying the service
exchange unit, then only the repair charge is payable. Otherwise the whole cost of a service
exchange unit becomes payable.
This procedure is by far the easiest and most cost-effective way of ensuring the monitor on board
conforms to IMO resolution MEPC.107(49).
Remark
According the MEPC.107(49) § 4.2.11 the units have to be checked at IOPP Certificate renewal
survey by the manufacturer or persons authorized by the manufacturer. Alternatively, the unit
may be replaced by a calibrated 15 ppm Bilge Alarm.
The OMD-2008 Series are designed in that way, that only the Measuring Cell needs to be changed,
as these units carry the Calibration Certificate. The Calibration Certificate with the date of the last
calibration check should be retained onboard for inspection purposes.
If for some reasons the Computer Unit needs to be changed, it has to make sure, that the memory
card will remain on board for at least 18 months. The new Computer Unit will carry its own
memory card. The old card can be inserted into the new unit only for reading. Writing is only
possible with the card delivered with the new Computer Unit. For details see section
15. Memory Card.
Warranty
Our warranty terms are 12 months after installation but maximum 18 months after delivery ex
works. The maker undertakes to remedy any defect resulting from faulty materials of
workmanship except wearing parts.
The maker's obligation is limited to the repairs or replacement of such defective parts by his own
plant or one of his authorized service stations.
The purchaser shall bear the cost and risk of transport of defective parts and repaired parts
supplied in replacement of such defective parts.
i
ANY DISMANTLING OR BREAKING OF A SEAL WILL VOID THE WARRANTY.
Page: 3 of 102