Operation Guide; Begin Programming; Record Enable; Security For Your Programs - ADJ SCENE SETTER 48 User Manual

O P E R A T I O N G U I D E

1. BEGIN PROGRAMMING

1.1 Record Enable.

1. Press and hold the Record button.
2. While holding down the Record button, tap Flash buttons 1, 6, 6 and 8 in sequence.
3. Release the Record button, and the Record LED will illuminate. You can now begin programming
your chase patterns.
NOTE: The first time you turn on your unit, the default setting of the Record Code is Flash buttons
1, 6, 6 and 8. You may change the Record Code to protect your programs.
RECORD

1.2 Security for Your Programs.

To protect your programs from any unauthorized changes, you may change the Record Code.
1. Enter current Record Code (Default code: Flash buttons 1, 6, 6 and 8).
2. Press and hold down the Record and Edit buttons at a time.
3. While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record
Code. The Record Code consists of 4 Flash buttons, and may include repeat numbers, if desired.
4. Enter your new Record Code a second time. If the change was successful, all channel LEDs and
scene LEDs will flash three times.
5. Exit Record mode. Tap the Rec Exit button while pressing and holding down the Record button,
then release both buttons at the same time. Record mode is now disengaged.
IMPORTANT!!!
Always remember to exit Record mode when you have finished programming, in order to
avoid inadvertantly losing control of your unit.
NOTE: When setting a new Record Code, this change can be canceled as long as you have not
completed Step 4 above (entering the new Record Code a second time). To cancel the change at
this time, press and hold the Record and Exit buttons together to exit without making the change.
1
+
12
6 6 8