Beam Angle Adjustment | Dmx Operation - ADJ PAR Z120 RGBW User Manual

BEAM ANGLE ADJUSTMENT
To adjust the beam angle, slide the beam
angle adjuster located inside/in front of the
lens. See diagram below.
The beam angle can be adjusted manually,
between 7°/11.5°/16°/20.5°/25°.
DMX OPERATION
DMX Controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be
affected at once. Turn on the unit, under the DMX signal; the LED will display the saved channel
address (001‐512).
Universal DMX Control: This function allows you to use a universal DMX-512 controller to control
the dimmer, fine dimmer and strobe. A DMX controller allows you to create unique programs tailored
to your individual needs.
1. The PAR Z120/ZP120 RGBW has 3 DMX channel modes; 1-channel mode, 2-channel mode
and 3-channel mode. See page 18 for a detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures on pages 12-15 as well as the set-
up specifications that are included with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instructions on page 9 to select your DMX channel mode and set your desired DMX
address.
6. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
7. For help operating in DMX mode consult the manual included with your DMX controller.
14