Table of Contents
Advertisement
O P E R AT I O N
Operating Power:
There are two ways to supply power to this unit; battery power or AC power.
•
AC Power - To run the unit using AC power, plug the unit into a power source, and put the Load
Switch into the ON position. When using AC power make sure the Battery Switch is in the OFF
position.
•
Battery Power - To run the unit using Battery power, put the Load and Battery Switches in the ON
position.
LED Display On/Off:
To set the LED display to turn off after 60 seconds, press the MODE but- ton until "don" is displayed,
press the UP button to display "doff". Now the display will disappear after 60s. Press any button to turn
the display on again. Be advised though that the display will turn off automatically after 10 seconds.
To set the display press the MODE button until "dXX" is displayed. Use the UP or DOWN buttons to
select either: "don" = LED display on at all times.
"doFF" = LED display shuts off after 60 seconds.
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display can be read upside down.
1. Plug the fixture in and press the MODE button until "dXX" is dis- played. "XX" represents either "on"
or "oFF".
2. Press the SET UP button until "Stnd" or "rev" is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Operating Modes:
The WiFly Par QA5 has five operating modes:
•
Static Color Mode - There are 15 colors to choose from.
•
RGBA Mode - Choose one of the four colors to remain static or adjust the intensity of each color to
make your desired color.
•
Auto Mode - There are 3 Auto Modes to choose from.
•
Sound-Active mode - The unit will react to sound, chasing through the built in programs.
•
DMX control mode - This function will allow you to control each individual fixtures traits with a
standard DMX 512 controller.
RGBA Dimmer Mode:
1. Plug the fixture in and press the MODE button until:
2. When "r.XXX" is displayed you are in Red dimming mode. Press the UP and DOWN buttons to
adjust intensity.
3. When "G.XXX" is displayed you are in Green dimming mode. Press the UP and DOWN buttons to
adjust intensity.
4. When "b.XXX" is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust intensity.
5. When "U.XXX" is displayed you are in Amber dimming mode. Press the UP and DOWN buttons to
adjust intensity.
6. After you have adjusted the RGBA colors to make your desired color you can then activate strobing
by pressing the SET UP button to enter the Flash (strobe) mode.
7. "FS.XX" will be displayed, this is Flash mode. The Flash can be adjusted between "FS.00" (flash
off) to "FS.15" (fastest flash).
Sound Active Mode:
In this mode the WiFly Par QA5 will react to sound, and chase through the different colors.
1. Plug the fixture in and press the MODE button until "SoXX" is displayed. "XX" represents the sound
active mode (01-16) currently displayed.
2. The fixture will now change via sound.
3. Press the SET UP button to adjust the sound sensitivity. "SJ-X" should be displayed. Use the UP or
DOWN buttons to adjust the sensitivity. "SJ-1" is the least sensitive, "SJ-8" is the most.
13
Advertisement
Table of Contents
