ADJ SCENE SETTER 48 User Manual page 29

B R I E F O F M A I N F U N C T I O N S
Dimmer Display.
1. The 3-Digit Segment Display is used to display intensity percentage or absolute DMX value.
2. To change between percentage and absolute value, press and hold the Shift Button. Then while
continuing to hold down the Shift button, press the % or 0-255 Button to switch between percent-
age and absolute values.
3. For example, if the Segment Display reads "076", it means a percentage value 76%. If the
Segment Display reads "076.", it means the DMX value 76.
Blind and Home.
1. The blind function temporarily removed channels from a chase while the chase is running, and
gives the user manual control over the channel.
2. Press and hold the Blind Button and tap the relative Flash Button you want to temporarily remove
the channel from the chase.
3. To return to normal chase again, press and hold the Home Button and push the Flash Button.
Park.
• In CHNS SCENES Mode, press the Park button changes the chasing mode of programs between
Single Mode and Mix Mode.
• In Double Preset Mode, pressing the Park button creates the same effect as pushing Master Slider
B to the top.
• In Single Preset Mode, this button could temporarily records the current output. Master Slider B
can then be used to make adjustments.
Add and Kill.
• The ADD/KILL Button changes the mode of the flash buttons. Normally, the flash buttons are in Add
mode, and pressing any flash button will not kill other scenes, allowing multiple scenes to be on at
a time.
• The Kill mode is activated by pressing the Add/Kill button. The LED above this button will illumi-
nate to indicate the device is in Kill mode. Pressing any flash button will now kill other active scenes
or programs.
• In Kill Mode, the killed program continues to run but simply produces no output.
Double Preset
• Press Mode Select Button to enter Double Preset Mode.
• In this mode, Channel Sliders 1-24 and channel sliders 25-48 both control Channel 1-24.
• Master A controls channel Slider 1-24, while Master B controls Channel Sliders 25-48.
• In this Mode, no scene can be recorded.
Example:
1. Enter the Double Preset Mode.
2. Push Channel Sliders 1 to 6 to the top and move Channel Sliders 19 to 24 to the maximum.
3. Move Master A and B to the same level and push them to the same direction. This will trigger a
scene.
29