Brief Of Main Functions - ADJ SCENE SETTER 48 User Manual

B R I E F O F M A I N F U N C T I O N S
Reverse the direction of the scene.
1. Press the ALL REV Button to make all the scenes change their directions.
2. To reverse the chasing direction of all the programs with speed control, press the Chase Rev
Button.
3. To reverse the chasing direction of all the programs with standard beat, press the Beat Rev
Button.
4. Reverse chasing direction of any program by pressing and holding the Rec One Button, then press-
ing down the Flash Button corresponding to your desired program. Release together.
Fade Time.
Adjust the amount of time it will take for the dimmer to go from zero output to maximum output and
vice versa. This setting is adjusted using the Fade Time Slider, which varies from instant to 10 minutes.
Tap Sync Button.
1. The Tap Sync button is used to set and synchronize the chase rate (the rate at which all scenes
will sequence) by tapping the button several times. The chase rate will synchronize to the time of
the last two taps. The LED above the Step Button will flash at the new chase rate. The chase rate
may be set anytime, whether or not a program is running.
2. Tap Sync will override any previous setting of the speed slider control until the slider is moved
again.
Master Slider.
• Master Slider control provides proportional level control over all channels and scenes with the
exception of the Flash Buttons. For example, whenever the Master slider control is at minimum, all
stage outputs will be at zero except for any resulting from a Flash Button or FULL ON Button. If the
Master is at 50%, all outputs will be at only 50% of the setting of current channel or scenes, except
for any resulting from a Flash Button or FULL ON Button.
• If the Master is at full, all outputs will follow the unit setting.
• Master A always controls outputs of channels.
• Master B controls the program or a scene, except in Double Preset Mode.
Single Mode.
1. All programs will run in sequential order of program number.
2. The Segment Display will show the running program number.
3. All programs will be controlled by the same Speed Slider.
4. Press the MODE SELECT BUTTON and select " CHNS SCENES.
5. Press the PARK BUTTON to select SINGLE CHASE MODE. A red LED will illuminate to indicate
the selection.
Mix Mode.
1. All programs run synchronously.
2. All programs can be controlled by the same SLIDER SPEED, or the speed of each program may
be controlled individually. (See Speed Setting ).
3. Press the MODE SELECT BUTTON and select "CHNS SCENES".
4. Press the PARK BUTTON to select MIX CHASE MODE. A yellow LED will illuminate to indicate
this selection.
28