Dmx Channels; Dmx Channel Setup; Add/Assign Dmx Channel; Remove Dmx Channel - ADJ SCENE SETTER 48 User Manual

D M X C H A N N E L S

1. DMX CHANNEL SETUP

1.1 Add/Assign DMX Channel.

1. Hold the Record button and press the Flash 8 button 3 times. This will access the DMX channel
setup. The display screen will show the current channel.
2. Use the Up and Down buttons to scroll to the desired DMX channel (1 to 512).
3. Press the desired Flash button (1 to 24) to assign the DMX channel to a console channel. The
LED on that console channel will illuminate to indicate that it has been selected.
4. Multiple DMX channels can be assigned to the same console channel, by repeating steps 2 and
3 for each additional channel. Please note that all DMX channels assigned to the same console
channel will respond in unison.
5. Hold the Record button and press Exit to leave this setup mode.

1.2 Remove DMX Channel.

1. Use the Up and Down buttons to scroll to the DMX channel you wish to remove.
2. Press the Blackout button. The channel should now be removed.

1.3 Assign All Console Channels to a Single DMX Channel.

1. Use the Up and Down buttons to scroll to a desired DMX channel.
2. Press the Full On button. All console channels are now tied to a single DMX channel.

2. CLEAR DMX CHANNEL SETUP

1. Make sure the device is in Record mode. Press and
hold the Record button.
2. Tap the Flash 7 button 3 times while holding down the
Record button. This allows the user to clear the DMX
channel setup and reset the DMX channels to the
default factory setting (1-24 channel sequence).

3. CALL 12 PRE-SET PROGRAMS

1. Make sure the device is in Record mode. Press and
hold the Record button.
2. Tap Flash 6, 6, 8, and 8 buttons in sequence while
holding the Record button. This allows the user to call
up the 12 factory default programs in page 1. Note that
all other programs will be cleared.
27