ADJ SCENE SETTER 48 User Manual page 14

O P E R A T I O N G U I D E
1.3 Program Scenes (continued).
7. Press a Flash button between 25-48 while holding
down the Record button. All LEDs will flash to indicate
that the scenes have been programmed into memory.
8. You can continue programming, or exit. To exit Program
mode, tap the Exit button while holding down the
Record button. The Record LED should turn off to indi-
cate that the device is no longer in Program mode.
Example: Program a 16 steps chase with channel 1-32 at
full in sequence into Flash button 25 of Page 1.
1. Record enable.
2. Push Master A & B to maximum position, and push
Fade slider to the top.
3. Tap the Mode Select button to select 1-48 Single mode.
4. Push Channel slider 1 to the top position. The slider's
LED light should be at full intensity.
5. Tap the Record button to program this step into mem-
ory.
6. Repeat steps 4 and 5 until you have assigned pro-
grams to Channel sliders 1-32.
7. Tap the Page button causing Page 1 LED lights.
8. Tap Flash button 25 while holding down the Record
button. All LEDs will flash to indicate that you have pro-
grammed the chase into memory.
14
10 10
8 8
RECORD
6 6
4 4
2 2
0 0
FLASH 25-48
RECORD
REC
EXIT