Deviser S7000 Operation Manual page 32

2.1.5.4 2.1.5.4 Edit Edit Tilt Tilt Plan Plan
2.1.5.4 2.1.5.4 Edit Edit Tilt Tilt Plan Plan
Up to sixteen channels can be tested in Tilt Measurement Mode. Select
ENTER ENTER
key (ENTER ENTER) to enable the channels you wish to add to the Tilt Measurement. (To disable a marked
channel, select key (ENTER
The "√" indicator is shown to mark the enabled channels. They will be displayed in sequence according
to their frequency value in the table, as shown in the Figure 2-20.
ESC ESC
Press key (ESC ESC) to exit, one dialog box will appear: Are you sure to save the changes? Select "YES"
to save and "NO" to exit without saving.
2.1.5.5 2.1.5.5 2.1.5.5 2.1.5.5 Satellite Satellite List Satellite Satellite List List List
Before attempting to use the SATELLITE function in S7000, user must edit the desired satellite list. Once
completed, this will allow S7000 to measure all the satellites automatically and save the various
measurement data.
Select keys (UP UP UP UP/DOWN DOWN DOWN) and DOWN
List. (To disable a marked satellite, select
satellites and select DISABLE DISABLE ALL DISABLE DISABLE
The "√" indicator is shown to mark the enabled satellites. They will be displayed in the table, as shown in
the Figure 2-21.
24
S7000 TV Analyzer
ENTER
ENTER ENTER) again.)
key (ENTER ENTER) to enable the satellites you wish to add to the Satellite ENTER ENTER
key (ENTER
ALL ALL ALL to disable all the satellites (except current satellite).
Operation Manual
Figure 2-20
ENTER ENTER ENTER) again.) Select ENABLE
keys (UP UP UP/DOWN UP DOWN) and DOWN DOWN
ENABLE ALL ENABLE ENABLE ALL to enable all the ALL ALL