Alpha ESS SMILE5 Installation Manual page 24

EMS INTRODUCTION AND SET UP
Note:
It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
Automatic display one parameter:
MAC Address: display MAC Address.
> > > Language < < <
> English
Deutsch
Figure 50 Date & Time Setting Interface
Step 20 Click Language to set
language
4.2.4.2 Additional Function Setting
A. If you use Backup box, please set as below:
> > Backupbox < <
> Enable
No
Step 1 Click Enable to set yes.
B. If external device will dispatch the system, please set as following steps:
> > > Function < < <
> Parallel
ModBus
Step 1 Please go to the function
menu, choose "ModBus" and press
enter.
42
> > Information <
> SN:
AL20020YYMMXXXX
Figure 51 Date & Time Setting Interface
Step 21 Make sure all the following
number is correct.
> > Backupbox < <
> L1 1 SOC 10
L1 2 SOC 10
L1 3 SOC 10
Step 2 Set the priority of the load,
L1＞L2＞L3
> > > ModBus < < <
> Enable OFF
Mode Slave
Step 2 Please set Modbus enable as
yes.
43
C. If you use cascading function please set as following steps:
> > > Function < < <
> Parallel
ModBus
Step 1 Please go to the function
menu, choose "Parallel" and press
enter.
> > Parallel < <
> Phase
L1
Step 3 Please choose "Phase" as L1
(master) and press enter.
Step 5 please repeat Step 1 to 4 to set the other device as L2 (slave) L3 (slave).
EMS INTRODUCTION AND SET UP
> > Parallel < <
> Select
Yes
Step 2 Please choose "Select" as
"Yes" and press enter.
> > Parallel < <
> Mode
Parallel Mode
Step 4 Please choose "Mode" as
"Parallel mode" and press enter.