Alpha ESS SMILE5 Installation Manual page 18

INSTALLATION
2.3.5.2 ADL3000
T E
000006.45
kWh
SET
T E
000006.45
kWh
SET
Step 1 The initial interface of the
meter (normal working mode) is
shown above.
000 1
Prog
SET
Step 3 Click the "Enter" button to
enter the above interface, and press
the up and down arrow keys to
enter the password 0001.
Prog
SET
Step 5 Click the "Enter" button
again to enter the address interface
Prog
SET
Step 7 Click the "Enter" button and
the address setting is completed.
There are 4 buttons on the front of the
electricity meter:
1. Enter button / Energy button
2. Down arrow / Power button
3. Up arrow / Voltage & current button
4. SET button
Prog
SET
Step 2 Click the "SET" button to
enter the password interface
Prog
SET
Step 4 Click the "Enter" button and
the password input is completed.
00 1
Addr Prog
SET
Step 6 Click the "Enter" button
and press the up and down arrow
keys to set the meter address. The
Grid meter (DC, AC and Hybrid
system) address is set to 001, the
PV meter (AC and Hybrid system)
address is set to 002.
30 31
Prog
Step 8 Click the "SET" button to
enter the following interface
Prog
Step 10 Click the "Enter" button to enter the following interface, press the up and
down arrow keys, and set "no" to "YES" to save the configuration.
Step 11 Click the "Enter" button and the setting is completed.
2.3.5.3 ACR10R
Ua 233.2 V
Ub 223.2 V
233.2
Uc V
F 49.97 Hz
FN Set
Ua 233.2
Ub 223.2
233.2
Uc
F 49.97
FN Set
Step 1 Activate the meter display by
pressing any key. Then click the "Set"
button.
Prog
SET
Step 9 Click the "SET" button again
to enter the save interface
Prog
SET
There are 5 buttons on the meter's front:
1. Enter key
2. Arrow to the right
3. Up arrow
4. SET button
5. FN key (no function)
V METER
V
HARM
V ENERG
Hz
I/O
FN
Step 2 Use the arrow keys to select the
"SETUP" menu item and confirm your
selection with the Enter key.
INSTALLATION
SET
SET
SOE
SETUP
Set