Alpha ESS SMILE5 Installation Manual page 23

EMS INTRODUCTION AND SET UP
> > > Battery < < < <
> Bat Model
Smile5-BAT
Step 5 Click the Battery Function and
check battery type SMILE5-BAT.
> > > Battery < < < <
> Battery Ready
No
Step 7 Check the Battery Ready
function set No. If you only use the
inverter without battery, please set it
Yes.
Max. Feed in rate
> User Value:
50%
Step 9 Set the Max. Feed in rate value.
> > > Work Mode < <
> Force Charge
Enable
Step 11 Click the mode then set up
work mode.(self-use or force time
charge)
40
> > > Battery < < < <
> SOC Calibration
No
Step 6 Check SOC Calibration
function set No.
> > > > > Grid < < < < <
> FeedIN Control
Power Limit
Power Factor
Step 8 Click the Grid Function to set
up relevant parameters of the grid
> > System Mode < <
> DC
AC
Hybrid
Step 10 Click Function-System
Mode to set system mode: DC, AC,
Hybrid.
> > > Work Mode < <
> Force Charge
Enable
Step 12 If you want to use force
charge, sett Enable here.
41
> > > Work Mode < <
> Charge
Start Time 1
01 ：00
Step 13 Set the charge and discharge
time.
> > > > Safety < < < <
> Country
AS4777
Step 15 Click Safety in the setting
menu. Set safety standard.
AS4777 for Australia, ARN4105 for
Germany, CEI0_21 for Italy, G83_2 for
Great Britain, NRS097_2_1 for South
Africa, RD1699 for Spain, VDE0216 for
60Hz countries.
> > UPS System < <
> Mute YES
Frequency: 50Hz
Step 17 If you use UPS function,
please set the mute as YES in UPS
System interface and the relevant
Frequency.
> > > Ethernet < < <
IP method
> DHCP
EMS INTRODUCTION AND SET UP
> > > Work Mode < <
> UPS Reserve SOC
11 %
Step 14 Set the UPS Reserve SOC, it
means how much battery energy to
reserve for UPS function.
> > > CT Meter < < <
> Enable OFF
Ratio 1
Step 16 If you use CT meter, please
set CT meter enable and the relevant
ratio.
> > > Date&Time < <
> 2018 - 02 - 02
09 : 46
Step 18 Click System in the setting
menu. Click Date &Time and set up
the date and time.
Step 17 Click Ethernet to set the IP
address. DHCP mode means that setup
IP address is set up automatically.
If you want to set up the IP address
manually, please choose manual mode.