Mcu Setting Dialog Box - Renesas M3028BT-EPB User Manual

M3028BT-EPB User's Manual

3.1.2 MCU Setting Dialog Box

MCU setting dialog box sets the information of the user system. It will be displayed after closing the Init dialog box.
When the tab settings of (1) to (3) have been finished, click "OK".
(1) MCU tab
1. MCU setting
Notes on Selecting a Processor Mode:
When the user system is connected, the level of pin CNVss of the MCU status should be "L". The MCU status
shows the pin level of the user system.
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
Specifying the processor mode
Select the appropriate processor mode that suits your
system. For this product, you can specify only the following
processor mode:
- Single-Chip Mode
Specifying the PM10 area (bit 0 of the
address 00005h)
Select this option when using the MCU in which the data
area access enable bit (PM10) is set to 1.
IMPORTANT
3. Usage (Emulator Debugger)
Page 47 of 86