Wavetek 3000 Instruction Manual page 9

GENERAL INFORMATION
1 .2 .7 Programmability
Frequency is programmable via rear panel
input connector using BCD-coded TTL voltages
or BCD-coded contact closures .
1 .2 .8 General
OPERATING TEMPERATURE
25 t5oC, all specifications apply
25 t15 0 C, with slight degradation of speci-
fications
OUTPUT CONNECTOR
Type N
RFI <1
VV is induced in a two-turn, one-inch
diameter loop which is held one inch away
from any surface . Loop feeds a 50 ohm re-
ceiver ;
POWER 115/230 V ±10%, 50/60 Hz, 40 VA
DIMENSIONS 12 in .
(30 .3 cm) wide, 5k in . (13 .4 cm)
high, 13 3/4 in . (34 .9 am) long
WEIGHT
25 lb . (11 .4 kg) net,
30 lb . (13 .6 kg)
shipping .
1 .3 OPTIONS
Options 1A, 1B, 4, and 7 are factory installed .
Option 3 may be factory or field installed .
1 .3 :1 RF Level Programming
For both Options 1A and 1B, the instruments
are calibrated for +13 dBm at 50 MHz like
a standard unit, but due to greater losses
in
Programmable Attenuators, a calibrated
output is only guaranteed to +12 dBm.
Option lA Program Level Range : 0 to 109 .9
dB in .1 dB steps
(programmed via
rear-panel plug) . 0 dB
reference is +13
dBm .
Front-panel level
range :
Continuously adjustable from +13
dBm
to
-97 dBm in 10
dB steps and an 11 dB
VERNIER .
Reverse power protection is also
provided by this option .
Option 1B Program Level Range : 0 to 90 dB
in
10 dB steps (programmed via rear-panel
plug) . 0 dB reference set by
front-panel
attenuators . Remote control of CW/AM mode
is also provided .
Front-panel Level Range : See Section 1 .2 .2 .
Reverse
power protection is also provided
by this option.