Wavetek 3000 Instruction Manual page 204

OPTION - 3
Install the M35-1 module in the location
Before use, the module should be tested
by the procedure shown in Operation
Check .
Note : The above information applies to
all 3000 Series instruments except Models
3002 and 3004 . For these instruments
the M35-1 is replaced by 1435-2, which
permits operation from .001 to 520 MHz,
but does not inlcude DC blocking . All
other specifications, operating instruc-
tions, and descriptions apply.
QTY
OPTION 3 FIELD INSTALLATION KIT
DESCRIPTION PART #
1 RF Circuit Breaker Module M35-1
1 RF Cable W1A
1 RF Cable WIB
1 6/32 x 5/8 Screw HS101-610
shown in Figure 8/3-2 and secure with
the 6-32 hold-down
screw . Remove the
front-panel RF
output cable, W1, and
replace with WlA
and W1 .B which will
route the RF
output signal thru the
?435-1 module .