ETAS ES930.1 User Manual page 78

ETAS
Problem
Data losses (packet
losses) occur during the
transfer.
The LED lights red.
The firmware of one or
several modules cannot
be updated.
1)
: The manufacturers of the PC cards refer to this function in different ways.
Example: "Link down Power saving"
ES930.1 - User Guide
Diagnostics questions
Are you using WLAN in
your measuring setup?
Are you using the correct
network card type in your
laptop?
Are you operating the
ES930.1 on a PC with
multi-core processor?
Did you just perform an
update?
Is the module to be
updated in a module
chain?
Handling of Problems
Possible solutions
WLAN is not allowed
within this ETAS net-
work. Use only ETAS
cables for the cabling of
your measuring setup
(ETAS modules and their
cable connection to the
PC).
Check whether you are
using a PCMCIA network
card in your laptop. PCM-
CIA cards with 8-bit or
16-bit data bus are not
suitable. Use only PCM-
CIA cards with 32-bit
data bus, mini-PCI or
ExpressCards.
Install a current driver for
the network card that
supports the NDIS proto-
col.
For users of the INCA/
INTECRIO/ ASCET-RP/
Configuration tool:
Switch the module off
and on again.
For users of the Config
tool:
Switch the module off
and on again.
Load the measuring con-
figuration again.
If the LED is still lit, return
the module to ETAS for
repair.
Update the firmware of
these ETAS daisy chain
modules separately.
78