Connecting Several Modules Mechanically; Fig. 11-2 Threaded Blind Hole - ETAS ES930.1 User Manual

ETAS
Fig. 11-2
Damage or destruction of the electronics is possible.
Do not rework the existing threaded hole.
NOTE
Screw the module onto your carrier system using exclusively M3 fillister head
screws and a max. torque of 0.8 Nm.
The maximum screw-in depth in the threaded blind hole of the housing is
3 mm (see Fig. 11-2 on page 67).
11.1.3

Connecting several Modules mechanically

Because of the use of ETAS system enclosures, the ES930.1 can also be com-
bined with modules of the ETAS compact series (ES59x, ES6xx, ES910). They
can simply be combined into larger blocks by using the supplied T-connectors.
An additional module of the ETAS compact series can be fastened underneath
the ES930.1. TO do so, remove the four respective plastic feet at the corre-
sponding device sides and install the supplied T-connectors in their place.
Connecting several modules mechanically:
ES930.1 - User Guide
Threaded blind Hole
CAUTION
1. Remove the four plastic feet on the underside of the ES930.1
to be able to fasten another module.
This exposes the installation openings for the T-connectors.
You can fasten an additional module underneath the ES930.1.
2. Remove the four plastic feet on the corresponding side of the
second module.
3. Turn the fasteners of the T-connectors transverse to the longi-
tudinal axis of the connectors
4. Click two connectors into the installation openings at one lon-
gitudinal side of the first module.
5. Click the second module into the two T-connectors.
Startup
M3
0.25 x 45°
67