Commissioning; Initial Commissioning; Running The Xv300 - Eaton XV300 Manual

4. Commissioning

4.1 Initial Commissioning

4. Commissioning
4.1 Initial Commissioning

4.2 Running the XV300

54
CAUTION
SHORT-CIRCUIT HAZARD
If the XV300 multi touch display is or has been exposed to envir-
onmental fluctuations (ambient temperature, air humidity), condensation
may form on or inside it. As long as this condensation is present, there
will be a short-circuit hazard.
Do not switch on the XV300 multi touch display when it has con-
densation in or on it.
If the XV300 has condensation in or on it, or if the panel has been
exposed to environmental fluctuations, let the panel settle into the exist-
ing ambient temperature before switching it on. Do not expose the
XV300 multi touch display to direct thermal radiation from heating appli-
ances.
Apply an XV300 to the 24 VDC supply voltage unit
The XV300 unit will boot up.
The XV300 multi touch display does not come with any runtime soft-
ware for visualization or PLCs installed.
The corresponding software packages can be used to install the
required runtime software on the XV300 unit.
Carry out the following steps once:
Configure the XV300 unit's system settings as necessary.
Install the required software packages.
Once the XV300 has been initially commissioned, it will run whenever it is connected to
the supply voltage.
In other words, it does not have to be separately switched on and off.
The Reducing the level of brightness will increase the backlight's
lifespan.
Siehe auch
System description Windows CE 7
XV300 04/19 MN048017EN www.eaton.eu
mn050004en