5. External connections
5.8 XV300 multi touch display as SmartWire-DT coordinator
5.8 XV300 multi touch display as SmartWire-DT coordinator
5.8.1 SmartWire-DT powered via POW/AUX
68
Applies only to XV300 SmartWire-DT units with a XV-3.3-..-.E.-...-.. connection.
In addition to the information in this document, you will also need the information in the
following documents in order to set up a SmartWire-DT network and install and operate
it using the SmartWire-DT master:
System description, engineering, installation, commissioning, and diagnostics for a
SWD network
SmartWire-DT The System Manual
Setup, engineering, installation, etc. for the individual SWD modules
Manual for SmartWire-DT IP20 modules
Manual for SmartWire-DT IP67 modules
The POW/AUX- interface is not electrically isolated.
CAUTION
NON-GALVANICALLY-ISOLATED INTERFACES
The XV300 may be damaged by potential differences.
The GND terminals of all bus modules must be connected.
Do not connect the connector to the XV300 or disconnect it without
first de-energizing the system.
Electrical connection
Power supply SmartWire-DT
POW/AUX
Figure 36: SmartWire-DT power connector
XV300 04/19 MN048017EN www.eaton.eu
MN05006002Z
MN05006001Z
MN120006