Table of Contents
Advertisement
3. Installation
3.4 Preparing the device for operation
Use the Plug connector MSTB 2.5/3-ST-5.08 to terminate the connection cable for
the power supply in advance.
Plug the pre-assembled plug into the socket on the enclosure.
Pay attention to the polarity.
Connect the power supply cable to a 24 VDC supply voltage that meets the require-
ments for safety extra-low voltages (SELV) set forth in IEC 60950 and – in con-
nection with the UL listing – the requirements for a low-voltage source set forth in
UL 61010-2-201.
The XV300 is now ready to run on 24 V
.
DC
XV300 04/19 MN048017EN www.eaton.eu
53
Advertisement
Table of Contents
