Figure 18: Peripheral Gasket Along The Entire - Eaton XV300 Manual

3. Installation
3.3 Mounting
Together with the gasket, this holding bracket is the main element involved in achieving
an IP65 (front) degree of protection.
The purpose of the holding brackets is to secure the XV300 onto a control panel, etc.
To this end, the brackets must be hooked into the enclosure sideways and screwed
against the control panel door, etc.
Make sure to position the holding brackets in such a way that they will push against the
center of the peripheral gasket.
Pre-install the holding brackets using the set screws.
Check that the gasket is in its correct position and pre-install the holding brackets
Figure 18: Peripheral gasket along the entire edge
XV-303-70-..and XV-303-10-..: foam rubber round cord, material NBR/PVC black, closed outer skin, dia-
meter 3 mm (0.12")
XV-303-15-..: Polyurethane foam gasket, material Raku-PUR 31-3117 black, dimensions 2mm x 3mm
(0.0787" x 0.1181")
XV300 04/19 MN048017EN www.eaton.eu
43