3.2 Unpacking and checking the equipment supplied
a separate line to the filer's PE connection.
l
Depending on the current consumption or configuration, several filters may be used as
well.
Check the HMI panel's packaging for transit damage.
Carefully remove the packaging in order to avoid damaging the device.
Check the package contents for visible transit damage.
Use the information in Installation instructions IL048009ZU or IL048010ZU to make
sure that the contents are complete.
Keep the original packaging so that you will be able to use it in the
future if you need to transport or ship the HMI panel.
Make sure to also keep the documents enclosed with the device
and/or to give them to the end customer.
The XV300 package includes:
Table 10: Std. pack
Number
Description
1 x
XV300
XV-303or XV-313
1 x
Plug connector MSTB 2.5/3-ST-5.08
1 x
Plug connector WAGO 734-104
Required only for XV-3.3-..-.E.-...-..XV300 units with a SmartWire-DT connection.
1 x
Installation instructions IL048009ZU or IL048010ZU
Holding bracket with set screw Internal hexagon M4x25 DIN 914 galvanized
6 x / 10 x /12 x
6 x for XV-303-70-..,
10 x for XV-303-10-..,
or
12 x for XV-303-15-..
The XV300 is sturdily built, but the components inside it are sensitive to excessively
strong vibrations and/or mechanical shock.
Accordingly, make sure to protect the XV300 from mechanical loads that exceed the
scope of the unit's intended use.
The XV300 should only be transported in its original packaging after being packed prop-
erly.
XV300 04/19 MN048017EN www.eaton.eu
3.2 Unpacking and checking the equipment supplied
3. Installation
41