LG SV-iC5 Series Instruction Manual page 45

LED Parameter
display name
F 0 [Jump code]
F 1 [Forward/
Reverse run
disable]
F 2 [Accel pattern]
F 3 [Decel pattern]
F 4 [Stop mode
select]
F 8 [DC Brake
1) start
frequency]
F 9 [DC Brake
wait time]
F10 [DC Brake
voltage]
F11 [DC Brake
time]
F12 [DC Brake
start voltage]
F13 [DC Brake
start time]
F14 [Time for
magnetizing a
motor]
1) : Set F4 to 1 (Stop via DC brake ) to view this function
Min/Max
range
0/60 This parameter sets the parameter code
number to jump.
0/2 0 Fwd and rev run enable
1 Forward run disable
2 Reverse run disable
0/1 0 Linear
1 S-curve
0/2 0 Decelerate to stop
1 Stop via DC brake
2 Free run to stop
0/60 [Hz] This parameter sets DC brake start
frequency.
It cannot be set below F23 - [Start
frequency].
0/60 [sec] When DC brake frequency is reached, the
inverter holds the output for the setting time
before starting DC brake.
0/200 This parameter sets the amount of DC
[%] voltage applied to a motor.
It is set in percent of H33 – [Motor rated
current].
0/60 [sec] This parameter sets the time taken to
apply DC current to a motor while motor is at
a stop.
0/200 This parameter sets the amount of DC
[%] voltage before a motor starts to run.
It is set in percent of H33 – [Motor rated
current].
0/60 [sec] DC voltage is applied to the motor for DC
Brake start time before motor accelerates.
0/60 [sec] This parameter applies the current to a
motor for the set time before motor
accelerates during Sensorless vector control.
Description
7-3
7. Function list
Function group 1
Factory Adjustable
defaults during run
1 O
0 X
0 X
0 X
5.0 X
0.1 X
50 X
1.0 X
50 X
0 X
1.0 X
SV-iC5
Page
5-5
9-8
9-13
9-18
10-1
10-1
10-1
10-1
10-2
10-2
10-11